sanjuro62 wrote:Ok, I'll take some hi-res pics tomorrow morning and some caliper measurements.
Sebik wrote:The one Sanjuro showed in the pics is for Yamaha Aerox/ MBK Nitro , the one mexicano has is for malaguti f12. i will post the pics with the subframe installed on my malaguti since i will mount the engine tommorow morning.
@Mexicano the ideea is the same as the aerox subframe it must be boltet to the frame like the one above.
sanjuro62 wrote:Cool, thanks for clearing that up. I couldn't remember if it was for the Aerox or Malagutti.
sanjuro62 wrote:That was the plan, but I never got around to it. It's also of course to allow for a rear facing carb setup, which I prefer.
The oem mount for the Grand Axis or Zuma is used in the ruckus motor swaps like seen on my bike below (see the tabs welded to the frame):
sanjuro62 wrote:I did the swap, but not with the carb facing the rear using the aerox subframe mount.
sanjuro62 wrote:Yes, it's still brand new, and never been installed. I'd happily sell it to you for the same cost as I paid ($123 + shipping).
Users browsing this forum: No registered users and 7 guests